9
TROUBLESHOOTING
You can perform your own troubleshooting at home based on the checklist given below.
However, if the problem persists, please consult your nearest authorized Electrolux
Service Centre.
PROBLEM POSSIBLE CAUSES CORRECTIONS
The vacuum cleaner The plug is not properly Check the plug connection
does not start. connected to the socket. or try another socket.
Thermal protector Press the ON/OFF button
activated due to and wait 20 - 30 minutes for
the motor to cool off. high temperature.
Filter indicator lights Dust container is full. Empty the dust container.
and stays on.
The filters are clogged. Clean or replace filters.
Reduction of Suction hose is blocked. Clean the hose.
suction capacity.
Nozzle is blocked. Clean the nozzle.
Dust container is full. Empty/replace the dust
container.
Filters are clogged. Clean or replace filters.
Hose is damaged Change the hose.
or broken.
Over heating. Dust container is full. Empty/replace the dust
container.
Filters are clogged. Clean/replace filters.
To locate your nearest Electrolux Service Centre, please contact your country’s Electrolux
Customer Care found on the last page of this booklet.
To Next Page
Loading...
Need help?
General
