6b
1a
1b
423
56a 7
8+10 9+12 11
English
REPLACING THE S-BAG™/CLEANING THE FILTER
1 The S-bag™ should be changed when the indicator win-
dow is completely red. Read with the nozzle lifted up (1a),
or when the window lights up (1b).
2 Remove the hose and open the lid.
3 Pull the cardboard holder to remove the s-bag™.
4 Insert a new bag by pushing the cardboard holder straight
down in its tracks. Close the lid.
Note! If the dust bag is obstructed, be sure to replace it immediately
even if it is not full.Also replace after vacuuming carpet-cleaning
powder. Be sure to use only an original Electrolux s-bag™ (Ref. No.
E200), s-bag™ Clinic (Ref. No. E202).
Replacing the motor filter (Ref. No. EF54) and charcoal
filter (Ref. No. EF28)
5 Remove the old filter (do this for each 5th replacement of
the dust bag).
6 Insert a new filter in the groove. (6a). (To make replacement
easier, open the lid by pressing on it as shown in picture 6b.)
7 Replace the filter and close the lid.
Replacing the micro filter (Ref. No. EF17) or the non
washable HEPA filter
8 Open and remove the lid, then remove the filter (do this for
each 5th replacement of the dust bag).
9 Insert a new filter and replace the lid as shown.
Cleaning the washable HEPA filter (Ref. No. EF26a)
(For each 5th replacement of the dust bag)
10 Open and remove the lid, then remove the filter.
11 Rinse the inside (dirty side) of the filter under warm tap
water. Tap the filter frame to remove excess water. Repeat
four times and allow the filter to dry.
Note! Do not use cleaning agents and avoid touching the delicate fil-
ter surface.
12 Replace the filter and lid as shown.
To Next Page
Loading...
Need help?
General
