Need help?Do you have a question about the Elkay EZH20 Series and is the answer not in the manual?
General| Installation Type | Wall Mounted |
|---|---|
| Filtered | Yes |
| Refrigerant Type | R-134a |
| ADA Compliant | Yes |
| Material | Stainless Steel |
| Product Type | Bottle Filling Station |
| Filter Included | Yes |
| Warranty | 5 Years |
| Cooling Capacity | 8.0 GPH |
| Power | 115V |
| Activation Method | Sensor |
| Water Flow Rate | 1.1 GPM |
| Spout Height | Varies by model |
Key instructions for correct installation, compliance, and important safety precautions.
Critical advice on preventing electrical feedback, electrolysis, and material selection.
Guide on using push-to-connect fittings for water supply lines.
Diagram showing overall dimensions, clearances, and connection points for rough-in installation.
Diagram showing dimensions and connection points for P model rough-in installation.
Detailed steps for installing the EWF3000 Watersentry Plus filter.
Guidance on making water supply connections and plumbing for both filtered and non-filtered units.
Visual representation of the plumbing layout for filtered and non-filtered units.
Guidance on mounting and securing the upper and lower panels.
Procedure for installing the filter cartridge in filtered units.
Steps for connecting power, checking for leaks, and testing unit functionality.
How to check the software designation (BF6, BF7, BF8) of the control board.
Steps to locate and access the programming button on the control board.
Procedure to reset the filter monitor indicator and reset the filter status.
Guide to adjust the sensitivity range of the IR sensor for bottle detection.
Instructions on how to reset the bottle counter to zero.
How to check the software designation (BF9) of the control board.
Steps to locate and access the programming button on the control board.
Procedure to reset the filter monitor indicator and reset the filter status.
Guide to adjust the sensitivity range of the IR sensor for bottle detection.
Configures unit type to adjust flow rate estimation for dispensed bottles.
Instructions on how to reset the bottle counter to zero.
How to check the software designation (BF11) of the control board.
Steps to locate and access the programming button on the control board.
Procedure to reset the filter monitor indicator and reset the filter status.
Guide to adjust the sensitivity range of the IR sensor for bottle detection.
Configures unit type to adjust flow rate estimation for dispensed bottles.
Procedure to select the filter capacity (e.g., 3000GAL or 6000GAL).
Instructions on how to reset the bottle counter to zero.
Detailed list of parts for the Watersentry Plus filter with item numbers and descriptions.
List of available replacement part kits for the unit.
Contact information for toll-free repair service and parts ordering.
To Next Page