Tinyhawk
14
emax-usa.com
Tinyhawk All-in-One Flight Controller
Tinyhawk’s main electronic board is shown above. This board contains a F4 flight
controller with all 4 esc’s and an 8CH receiver.
Emax Tiny Receiver
Number of Channels: Up to 8CH using SBUS
Compatibility: FrSky D8 mode
Binding Procedure
Binding is the process of uniquely associating a particular receiver to a transmitter
module. A transmitter
module can be bound to multiple receivers (not to be used simultaneously). A
receiver can only be bound to one transmitter module.
1.Hold the bind button while powering on the receiver. When the GREEN LED is on,
it means the receiver is in BIND MODE
2.Turn on the transmitter, make sure it is set to D8 mode, and then set it into bind
status. When the RED LED of the receiver starts flashing, it means bind successful.
3.Turn on the transmitter again, the GREEN LED receiver will be on, it means the
receiver is receiving data from transmitter. Transmitter bind with receiver no need
repetitive operation, unless you change either receiver or transmitter.
Emax Tinyhawk Flight Controller (FC)
This flight controller has a F4 MCU with a MPU6000 gyro. Tinyhawk flight controller
comes pre-programmed and properly tuned for optimal flight. The flight controller is
programmed with Betaflight 3.5.0. For a full tune and configuration setting file (CLI
dump file) please visit https://emax-usa.com/ for the CLI dump file.
Stock Flight Controller Settings
Tinyhawk is configured to take a channel map of the AETR1234 convention. That is
the channel map is in the respective order: throttle, aileron, elevator, rudder, AUX 1,
and AUX 2. The arm switch on tinyhawk is set on AUX 2 and armed with the highest
value. The middle stage of AUX 2 activates the beeper. AUX 1 is configured for a 3
stage switch to select flight modes: Angle, Horizon, and Acro activating in an
increasing order. The stock radio controller is already configured to these settings. If
To Next Page
Loading...
Need help?
General
