1 Introduction
1.1 Safety messages
Instructions in this manual may require special precautions to ensure the safety of the
personnel performing the operations.
This AMS Wireless Vibration Monitor device complies with Part 15 of the FCC Rules.
Operation is subject to the following conditions: This device may not cause harmful
interference, this device must accept any interference received, including interference
that may cause undesired operation.
This device must be installed to ensure a minimum antenna separation of 20 cm from all
persons.
Refer to the following safety messages before performing an operation preceded by the
warning symbol:
WARNING
Failure to follow these installation guidelines can result in death or serious injury. Only
qualified personnel should install the AMS Wireless Vibration Monitor.
Explosions could result in death or serious injury:
• Before connecting a Field Communicator in an explosive environment, make sure the
instruments are installed in accordance with applicable field wiring practices.
• Verify that the operating environment of the AMS Wireless Vibration Monitor is
consistent with the appropriate hazardous locations certifications.
User Guide Introduction
MHM-97927-PBF July 2020
MHM-97927-PBF, DRAFT 5
To Next Page
Need help?
General
