Emerson LC391EM3 User Manual

English
21
• When the scanning and memorizing are completed, the lowest
memorized channel will be displayed.
Autoprogram
Please wait while the system is scanning for channels.
Auto programming may take more than 20 minutes to
complete.
75%
Digital channels
10 ch
Analog channels
6 ch
Exit
Note
• After setting Autoprogram, using CH + / − skips unavailable programs automatically.
• If you are not receiving a signal from your cable service, contact the Cable provider.
• If you press or MENU during autoprogram, the setup of TV channels will be
canceled.
• Even if Autoprogram is completed, the channel setting will be lost if the AC power
cord is unplugged before the unit goes into Standby mode by pressing
.
• The PIN Code will be required once you set a PIN code in the Child and ratings lock.
➠
p. 23
• If you want to change your PIN code, follow the instruction of Change PIN.
➠
p. 25
Channel list
The channels selected here can be skipped when selecting the channels
using CH + / −.
Those channels can still be selected with the NUMBER buttons.
1 Use ▲▼ to select Channel list, then press OK.
2 Use ▲▼ to select the channel you want to remove, then press
OK.
Picture DTV 11.1
Sound
Highlight channels for
Ch Up / Down key selection.
DTV 11.2
Setup
DTV 11.3
Features
Language
USB
Ch Select Watch / Skip Back
• The channel display for the removed channel darkens. You will
not be able to select the channel again using CH + / −.
• To reactivate a removed channel, use ▲▼ and press OK. The
registered channels are highlighted.
• When you remove a main channel, its subchannels are removed
as well.
Note
• The channel with DTV indicated on the display is ATSC. Otherwise the channel is
Analog TV.
Add channels
This function lets you add the off the air Analog TV or Analog Cable
channels that were not added by the autoprogram due to reception
conditions during the initial setting.
1 Use ▲▼ to select Add channels, then press OK.
2 Use the NUMBER buttons to enter the number of the channel you
want to add, then press OK.
Picture Add channels
Sound
For analog channels, select a
channel to be added using
number keys.
For digital channels, you must
perform Autoprogram function.
Setup
Features
Language
USB
Ch Change Back
Note
• If setup completes successfully, Added to the channel list. is displayed.
• If external Input is used, it is not possible to register the channel and Unavailable will be
displayed on the TV screen.
• Some channels cannot be selected by CH + / −. Use the NUMBER buttons to select
the memorised channels.
Antenna conrmation
Digital TV operation
This function lets you check the Digital signal strength of each channel.
1 Use ▲▼ to select Antenna, then press OK.
2 Use the NUMBER buttons or CH + / − to select the channel for
which you want to check the Digital signal strength.
Picture Back
Sound
Setup
Current 50
Max 50
Features
Language
USB
Ch Change
Note
• If the channel is set to Analog channel or external Input, you cannot conrm the
antenna condition.

Emerson LC391EM3 Specifications

General

Brand	Emerson
Model	LC391EM3
Category	LCD TV
Language	English