CKS1900-20221202-01 Printed in China
◀
▶
▲
▼
▲
▼
STO.
▲
▼
STO.
MEM.
▲
▼
briefly
steps below:
a long wire located at the back.Extend this antenna wire
2) Press and hold the AL1 (AL2) button until the display blinks and changes from the
current time to the Alarm1 or Alarm2 wake up time.
3) Release the AL1 (AL2) button, press the ◀or ▶button to adjust Hour, and press the
▼or ▲button to adjust Minutes.
4) Press the AL1 (AL2) button again, press the ▼or ▲button to adjust alarm volume
(V01~V16) that will come on at wake up time.
5) Press the AL1 (AL2) button again, press the ◀or ▶button to select alarm week mode
(d1-7 everyday, d1-5 weekdays or d6-7 weekends only), if necessary.
6) Press the AL1 (AL2) button to save the alarm settings.
7) Press the AL1 (AL2) button repeatedly, if necessary, until 1♫(2♫) indicator glows
(alarm activated)
8
9
10
reaches
AL1
ON/OFF
Week
1 or 2
1 2
Note: Wake-to-buzzer alarm volume is fixed, cannot be adjusted.
ON/OFF button once.
There is a gap next to the marking ^, that can be filled by fingernail for lifting up the battery
holder.
CLOCK SET
previous page to
Follow the instructions on sections Setting the Year/Date/Time to set the clock to
the correct year,date and time
Press the CLOCK SET button repeatedly to check the year,date and time.
Make final adjustment if necessary.
3 to 5
(1♫ or 2♫)
fully and orient it for better FM reception.
band the BAND
BAND
Press the AL1 (AL2) button repeatedly to turn the Alarm1 (Alarm2) lndicator On.
Press the ON/OFF button to turn ON the radio first.
Then press
(default sleep timer setting).
To Previous Page
Loading...
Need help?
General
