7
• Insert a new CR2032 3 V battery. Make sure you observe the correct polarity. Use primary batteries
only, not rechargeable ones.
• Close the cover.
Pairing
• Connect the receiver to mains power.
• Press and hold the ON button on the desired button row of the remote controller.
• The devices are now paired.
Cancelling Pairing
• If you wish to cancel pairing, you must rst unplug the receiver and plug it in again.
• Then, press the OFF button on the row you wish to unpair and hold it for 30 seconds.
• The device is now disconnected from the remote controller.
• If you wish to pair the device again, you must rst unplug and replug the receiver.
Important Warning
• Only a lead-in cable (not an appliance with a direct plug) can be plugged into the remote-con-
trolled socket.
• The remote-controlled sockets must be connected to a 230 V AC/50 Hz power grid tted with
circuit protection.
• Only appliances powered by 230 V AC/50 Hz voltage may be connected to the sockets.
• Pay attention to the data on the type label of the appliances connected to the device.
• Maximum input power of connected electrical appliances must not exceed 3 000 W (max. current 13 A).
• The remote controller is powered by type CR2032 primary batteries. Do not recharge, short circuit
or destroy the batteries or throw them in a re. Do not combine new and old batteries, dierent
types, systems or brands. Remove the batteries if the device is not being used for a longer period
of time. Store the batteries out of range of children.
• Any use of the device not listed in the previous sections of the instructions will result in damage
to the product and could cause danger in the form of a short circuit, injury by electric current, etc.
The product must not be altered or otherwise restructured! Safety warnings must be followed
unconditionally. We take no responsibility for material damage and injury to persons caused by
improper use of the product or disregard of instructions and safety warnings listed in the manual.
Any claim for warranty is voided in these cases.
• Make sure that the lead-in earth pin is not damaged – a damaged earth pin could endanger
the life of the user.
• Do not expose the product to direct sunlight and protect it against heat.
• The device must not be used in adverse environments such as environments with ammable
gases, vapours or dust.
• For safety reasons, never use the device in environments with extreme humidity (saunas, vapours)
or if water has entered its interior.
To Next Page
Loading...
Need help?
General
