- 19 -
Minimum regulation of the oven knob
c) Regulate the oven burner minimum:
Turn the knob first to the Max setting for about 10 minutes and then to Min;
Remove the knob
Remove the disk fastened to the control panel
Adjust the screw located outside the thermostat cock pin until the flame is small but steady ( the flame can
be seen through the slots on the oven bottom)
N.B.: In this case of liquid gas, the regulation screw must be screwed in all the way.
Check that the burner does no turn off when you turn the knob from Max to Min quickly and when you open and
close the oven door quickly.
Warning
On completion of this operation, replace the old drating sticker with one indicating the new type of gas used.
This sticker is available from our Service Centers.
Note Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to
fit a suitable pressure regulator onto the inlet pipe ( in compliance with the current National Norms regarding
“regulators for channeled gas”
Technical Specifications
Inner dimensions of the oven:
Width：44.4cm
Depth：43.2cm
Height：30.5cm
Overall dimensions for oven volume: 58liters
This appliance conforms with the following
European economic community directives:
-2009/95/EC (Low Voltage);
-2004/108/EC (Electromagnetic compatibility);
-2009/142/EC ( Appliances burning gaseous fuels);
To Next Page
Loading...
Need help?
General
