pg.14
EA-AMP-70 Installation and Users Manual
Continuous Power Output
All channels driven
50 watts RMS at 8 ohms
70 watts RMS at 4 ohms
Bridged Power Output
All channels driven
140 Watts per channel RMS at 8 ohms
Note: Maintain 8 ohm minimum when using bridge mode
Input Sensitivity 500mV
Input Impedance 20,000 ohms
S/N ratio 95 dB
Frequency Response 20 Hz to 20 kHz
Distortion (Unbridged) 0.1% THD 20 Hz-20 kHz
Distortion (Bridged) 0.1% THD 20 Hz-20 kHz
Dimensions 17”w x 4”h (including feet) x 13” deep
Weight
8 ch: 25.3lbs / 12 ch: 32lbs
Certication Meets FCC Part 15, ETL Listed and tested under UL/EN60065
*All specications are subject to change without notice
SPECIFICATIONS
WARRANTY
2-Year Limited Warranty
Episode
®
Amplier Products have a 2-Year Limited Warranty. This warranty includes parts and labor repairs on all
components found to be defective in material or workmanship under normal conditions of use. This warranty shall
not apply to products which have been abused, modied or disassembled. Products to be repaired under this warranty
must be returned to SnapAV or a designated service center with prior notication and an assigned return
authorization number (RA).
To Next Page
Loading...
Need help?
General