26
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.
1. Press the WPS button on your router or access point.
2. Hold down the Wi-Fi button on your product for about five seconds until the Wi-Fi light and Wi-
Fi Direct light flash alternately.
The Wi-Fi light turns green to indicate a successful connection.
Note: Be sure to press and hold the Wi-Fi button on your product within 2 minutes of pressing the
WPS button on your router or access point.
Parent topic: Wi-Fi Protected Setup (WPS)
Printing a Network Status Sheet
You can print a network status sheet to help you determine the causes of any problems you may have
using your product on a network.
To print the status sheet, hold down the network status button on the product for at least five seconds.
Note: If you release the button before five seconds elapses, a network connection report is printed
instead of a network status sheet.
Examine the settings shown on the network status sheet to diagnose any problems you may have.
Parent topic: Wi-Fi or Wired Networking
Related tasks
Printing a Network Connection Report
Printing a Network Connection Report
You can print a network connection report to view solutions to any problems you may have using your
product on a network.
To print the report, press the network status button on the product.
Examine the error codes and solutions shown on the network connection report.
Network Connection Report Codes and Messages
Parent topic: Wi-Fi or Wired Networking
To Next Page
Loading...
Need help?
General
Weight and Dimensions
