3. INSTALLATION
●
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualied persons in order to avoid a hazard.
●
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device, such as
a timer, or connected to a circuit that is regularly switched on and o by the utility.
●
WARNING: In order to avoid overheating, do not cover the heater.
●
The heater must not be located immediately below a socket-outlet.
●
Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
Your appliance shall be used as portable appliance only (thanks to respect all the safety
warnings given below)
Put the heater on a at, dry and clean surface.
Let a minimum distance of 1m between any side of your appliance and any obstacle
(furniture or walls, for example) to allow a good circulation of the airow. Always direct
the airow in order to optimize the heating of the room. Avoid the corners, small
volumes, wood oors, ceiling, etc…
4. HOW TO USE
Plug the appliance to a 220-240V
~
50-60Hz socket.
To start the heater, put the switch on the position (Low power) or on the
position (High power).
Set the temperature with the switches - / +.
To stop the heater, put the switch on the position 0.
Unplug the product when it’s not in use.
5. CLEANING & MAINTENANCE
Always disconnect appliance from the main when you clean it.
In order to avoid any hazard, only clean the appliance with a dry rag lightly humidied.
NEVER IMMERSE THE HEATER TO CLEAN IT
To avoid any electrical hazard, clean your appliance with a soft and clean rag to remove
the dust. You can also use a vacuum cleaner to clean the air openings.
Clean your appliance regularly
FR
ES
PT
IT
EL
PL
UA
RO
EN
37
To Next Page
Loading...
Need help?
General