ESAB Rogue Series User Manual

4 INSTALLATION
0463 732 001
- 12 -
© ESAB AB 2020
4.3 Mains supply
NOTE!
Rogue ES 150i and ES 180i do not comply with IEC 61000-3-12. If it is connected to
a public low voltage system, it is the responsibility of the installer or user of the
equipment to ensure, by consultation with the distribution network operator if
necessary, that the equipment may be connected.
The power source will automatically adjust to the supplied input voltage. Make sure that it is
protected by the correct fuse rating. A protective ground connection must be made, in
accordance with regulations.
1.
Rating plate with supply connection
data.
Recommended fuse sizes and minimum cable area for the Rogue ES 150i, ES 180i
Rogue ES 150i ES 180i
Supply voltage 230VAC 230VAC
Electrical cable area 2.5mm
2
2.5mm
2
Maximal current rating
I
max
MMA/Stick (SMAW)
30A 36A
I1eff MMA/Stick (SMAW) 15A 16A
Fuse anti-surge type D MCB 20A 20A

ESAB Rogue Series Specifications

General

Brand	ESAB
Model	Rogue Series
Category	Welding System
Language	English