15
Removing the Door for Easier Cleaning
1. We recommend you have someone to assist you during removal
of the door.
2. Open the door completely.
3. The door hinge has a small latch. Lift the latch on both hinges.
4. Lift the door slightly as if closing, and then with both hands
supporting the door, pull it away from the oven.
5. To replace the door, perform the above in reverse order. Ensure
the slot on the bottom of the hinge is seated when retting the
door. Open and close the door to make sure that it has been
tted correctly.
Taking out the Glass from the Oven Door for Cleaning
1. Remove the oven door.
2. Undo the screws from the metal panel that holds the glass
in place.
• Ensure the appliance is switched o before replacing the light to avoid the possibility of electric shock.
• Take care when handling parts with glass.
It may require a little force due to the adhesive pads
under glass. Take care not to break the glass.
3. Lift the glass out of the frame. Clean it using appropriate glass
cleaning products.
4. To replace the glass, place it back in, placing the securing caps
over the top of the glass and screw it back into place.
5. Ensure the glass is not damaged in any way.
Replacing the Oven Light
1. Turn o the oven and make sure that it is cold. Switch o its
isolation switch.
2. Unscrew the glass cover in front of the light, unscrew and take
out the bulb.
3. Screw in the new bulb, which should be resistant to 300°C.
For replacement bulbs contact your local service centre or
Partmaster Direct (details at the back of this guide).
4. Re-t the cover.
5. If in any doubt, consult a qualied electrician for help.
Currys Essentials Built in Oven CBCONX18 Manual.indd 15 05/11/2018 16:45
To Next Page
Loading...
Need help?
General
