GB
19 / 40
– The power cord of the adapter must not be damaged with sharp or hot objects, open fire
and it must not be sunk into water.
– The cable supplied with this appliance is intended for this appliance only, do not use it for other
purposes. Also, use only the supplied cable with this appliance, do not use any other cable for
charging (e.g. from another appliance).
– Never use the appliance for any other purpose than for the intended purpose described in these
instructions for use!
– The producer is not responsible for any loss caused by improper handling of the appliance
and its accessories (e. g. injury, appliance damage, fire, etc.) and its guarantee for the appliance
does not apply in the case of non-compliance with the safety instructions above.
II. DESCRIPTION OF THE APPLIANCE AND ITS ACCESSORIES (fig. 1)
A – trimmer
A1 – trimming head, blades
A2 – blade cut length switch (1-10 / 11-20 mm)
A3 – ON/OFF/lock switch
A4 – socket for charging
A5 – LED indicator
B – combs
BA – comb attachment (1–10 mm)
BB – comb attachment (11–20 mm)
C – blade lubrication oil
D – brush
E – USB-C cabel
F – travel case
III. INSTRUCTIONS FOR USE
Before you can use the appliance, its batteries must be charged. The operation time for one charge
depends on the attachment used and workload. Attachment is around 90 minutes.
Charging adapter
The appliance has no charging source of its own, it is only designed for charging via USB (an
adapter with USB output, with output voltage of 5.0 V, and output current of at least 1000 mA).
Before making any connection, please pay attention to instructions of the manufacturer of the
respective power source..
To Charge/Recharge
–
Fully charge Clipper before using for the first time or after non- use for a long period of time.
–
Battery performance is best if you recharge only when the battery is (almost) completely empty.
– Charging or recharging at temperatures below 10°C or higher than 40°C adversely
affects lifespan of the battery.
– Continuously recharging Clipper will reduce lifespan of battery.
1) Be certain Clipper is OFF.
2) Connect the trimmer to the adapter and plug the adapter to the mains.
3)
It will take approximately 2 hours to fully charge the Clipper. Do not exceed the set time of charging!
4) After charging, unplug the adaptor from the mains rst and only then unplug the connector from
the appliance.
Optimize the working life of the battery
– Do not charge for more than 2 hours.
– Do not keep cord permanently plugged in.
To Next Page
Loading...
Need help?
General
