Eureka 3670 Series User Manual

6 Eureka Customer Service HELPLINE 1-800-282-2886
How to use your vacuum cleaner
CAUTION: Do not plug in cleaner until you
understand all controls and features.
To Clean Bare Floors and Rugs
Step 1: Attach wands to hose handle.
Step 2: Place oor tool on end of wand. Press button
back to lower brush for bare oors. Press
button forward to raise brush for carpets.
Step 3: For models with telescopic wands, extend
wands by pushing lock button down and
pulling on lower wand until reaching desired
height (Fig. 6).
Step 4: Adjust to maximum suction by closing the slip
ring
K
on the hose handle (Fig. 6).
Step 5: Rotate swivel cord hook
L
on bottom of
canister to release cord (Fig. 7).
Step 6: Plug cord into appropriate outlet.
Step 7: Push on/off switch
M
. Press once to turn on.
Press again to turn off (Fig. 8).
To Clean Stairs, Upholstery and
Window Treatments
(see page 4 for accessory details)
Step 1: Attach combination tool, crevice tool or turbo
nozzle (on some models only) to the end of the
hose. If additional reach is needed place wand
on hose handle rst.
Step 2: Adjust to minimum suction by opening the slip
ring
K
on the hose handle (Fig. 6).
Step 3: Rotate swivel cord hook
L
on bottom of
canister to release cord (Fig. 7).
Step 4: Plug cord into an appropriate outlet.
Step 5: Push on/off switch
M
. Press once to turn on.
Press again to turn off (Fig. 8).
To Use Blower Port
Step 1: Remove HEPA lter (on some models only).
See page 8 for details.
Step 2: Detach hose
B
from front of canister
A
and
attach to the blower port
J
on the back side of
the canister (Fig. 9).
Step 3: Rotate swivel cord hook
L
on bottom of
canister to release cord (Fig. 7).
Step 4: Plug cord into appropriate outlet.
Step 5: Push on/off switch
M
. Press once to turn on.
Press again to turn off (Fig. 8).
Fig. 6
Fig. 7
Fig. 8
Fig. 9

Eureka 3670 Series Specifications

General

Brand	Eureka
Model	3670 Series
Category	Vacuum Cleaner
Language	English