Care &
STORAGE
DEFROSTING
• Switch off freezer and open lid.
• Open drainage bung to drain waste as
fridge defrosts.
• A jug of water may be poured over the
evaporator plates and inside of the
cabinet to assist cleaning. (DO NOT
FLOOD OR FILL THE CABINET WITH
WATER.)
• DO NOT use sharp objects when
cleaning and defrosting your EvaKool.
Keep your EvaKool clean by wiping
both the interior and exterior with
a damp cloth using a mild non-
abrasive household detergent and dry
thoroughly.
• Ensure fridge is completely defrosted
and dry before turning back on.
• Always clean the fridge afte use and
before storage.
STORAGE
• When storing your EvaKool for any
lengthy period prop the lid open a
few millimetres and remove bung cap
to prevent the build-up of mould or
odours. Spray interior, if necessary, with
a food grade anti-mould/odour product.
• We recommend that your fridge is
operated at regular intervals if it is
being stored for any length of time.
Remember your EvaKool can be used
in the home as an additional fridge or
freezer by using your EvaPower AC
adaptor. (see page ??)
WARNING
Do not place your AC adaptor or any
electrical equipment inside your fridge
as condensation and moisture will
cause the electronics to fuse or burn
out, voiding the warranty.
PREVENTATIVE MAINTENANCE
As your EvaKool is a portable unit it
is likely to be subjected to a variety of
different operating conditions.
Accordingly in terms of our warranty you
are obliged to have the unit regularly
inspected by an approved EvaKool service
agent. See warranty statement.
Prior to commencing any maintenance
ensure the unitis not operating and is
disconnected from a power source.
The unit is designed so preventative
maintenance is easy for the owner to undertake.
Simply remove the 6 screws holding the
compressor cover in place, drop the cover
forward and using a small brush, vacuum
or compressed air, clean any dust or dirt
fro the condenser coils.
DO NOT USE WATER TO CLEAN THE
CONDENSER COILS. FAILURE TO
REGULARLY CLEAN THE COILS MAY
VOID THE WARRANTY.
If the unit is exposed to rain or water,
remove the cover and dry as necessary.
If regularly exposed to moisture spray
the compressor, condenser etc with a
protective product such as LANOGARD or
WD40 at least every 3 months.
To Next Page
Loading...
Need help?
General
