8
Engine Operation
FILL WATER
Before starting the engine, remove the filler plug from the pump
chamber, and completely fill the pump chamber with water.
Reinstall the filler plug and tighten it securely.
TURNING THE ENGINE ON
□ The ignition switch (1) controls the ignition. Move it to
the ON position to start the engine. The same control is
used to stop the engine.
□ Adjust the choke lever (3).
□ Pull the recoil starter grip (2) on the recoil starter.
NOTE: Before starting a cold engine, you MUST move the
choke lever (3) to the left (closed). As the engine warms up,
move it towards the right (open). A warm engine should
start with the choke open.
STOPPING THE ENGINE
□ Stop the engine by turning the ignition switch (1) to OFF.
□ Move the fuel valve lever (2) to OFF (left).
Filler plug
3
1
2
12
To Next Page
Loading...
