Fender '57 CUSTOM CHAMP User Manual

ENGLISH
Specifications
TYPE PR 863
POWER Requirements: 60 watts Output: 5 watts
IMPEDANCE 1 MΩ
SPEAKER One 8” Weber alnico (4Ω, PN 0077212000)
TUBES One 6V6GTA (power, PN 0023564000) One 12AY7 (preamp, PN 7708740000)
One 5Y3GT (rectifier, PN 0023614000)
FUSE F1.25A L 250V (100V-120V models) F1.0A L 250V (220V-240V models)
ACCESSORIES Deluxe fitted cover (included, PN 7708597000)
DIMENSIONS Width: 13.5” (34.3 cm) Height: 12.5” (31.8 cm) Depth: 7.6” (19.3 cm)
WEIGHT 15 lbs. (6.8 kg)
Product specifications subject to change without notice.
Chassis Rear View
F. POWER CORD: Connect to a grounded outlet in ac-
cordance with the voltage and frequency specications
noted on the amplier information label, which is located
inside the cabinet on the left when viewing from the rear.
G. FUSE: Provides electrical over-current protection. With
power disconnected, replace a blown fuse only with one
of the type and rating specied on the safety label.
H. RECTIFIER TUBE: Single 5Y3GT rectier tube converts AC
voltage from the amplier’s power transformer into DC
voltage required by the power (I) and preamp (K) tubes. It
should be replaced only with an identical rectier tube or
one with a comparable rating and quality.
I. POWER TUBE: Single 6V6GTA power tube drives the
power section of the amplier. It should be replaced only
with an identical power tube or one with a comparable
rating and quality.
J. SPEAKER OUTPUT JACK: The ’57 Custom Champ’s
single 4-ohm internal speaker connects here, or a 4-ohm
external speaker enclosure (5 watts minimum) can be
connected instead. In either case, to prevent damage to
the amplier, a minimum 4-ohm speaker load must be
connected when power is on.
K. PREAMP TUBE: Single 12AY7 preamp tube drives the
preamp section of the amplier. It should be replaced
only with an identical preamp tube or one with a compa-
rable rating and quality, however, a 12AX7A preamp tube
may be substituted in order to achieve more distortion at
higher volume levels.
Rear panel, tube cage, preamp tube shields and other parts removed for illustration.
For questions and troubleshooting, contact a
Fender specialist at:
--- (U.S. toll free)
--- (International)
3

Fender '57 CUSTOM CHAMP Specifications

General

Brand	Fender
Model	'57 CUSTOM CHAMP
Category	Amplifier
Language	English