- Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Arrange
cord away from traffic area and where it will not be tripped over.
- This heater may get hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles
when moving this heater.
- Always turn off the unit before moving or cleaning, or whenever the heater is not in use.
- Never move or lift the heater by pulling its power cable.
ASSEMBLY INSTRUCTIONS
- When unpacking check the heater and its components for transport damage and make sure it’s all there.
- Before assembling and using the device, remove protective packaging. Clear away the packing materials
immediately. They can be dangerous for children and animals.
- By assembling the heater consider the safeguard distances as shown in the figure.
- The voltage available must not exceed the voltage stated in the specifications of the patio heater.
- Be careful during assembly. Do not touch live wires.
- Never insert the plug in the socket before the heater is completely assembled and installed.
- Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire.
- The power cable must never come in contact with the heater or hot parts of the heater. Keep the power cord at a
safe distance.
- The heater shall not be located immediately below a socket-outlet.
- For safety reasons, you must be in a position to pull the plug from the socket immediately in a safe manner.
- Never install the heater on flammable materials like wood. Fire hazard!
- It’s dangerous to install the appliance close to curtains and other combustible materials. Fire hazard!
- Connect to properly grounded outlets only.
- The marking concerning covering shall be visible after the heater has been installed.
SUPPLIED PARTS
- 1 patio heater
- 1 chain
- 1 self tapping hook screw
To Next Page
Loading...
Need help?
General
