PROBLEM SOLUTION
Smoke alarm does not Check that AC power is
sound when tested. turned on.
NOTE: Push and hold test
button for at least five (5)
seconds when testing.
LED blinks and alarm beeps Battery is low – REPLACE
simultaneously every 60 IT IMMEDIATELY!
seconds.
LED blinks and 30 seconds Unit inoperable. REPLACE
later alarm beeps – repeats OR RETURN FOR REPAIR
at 60 second intervals. IMMEDIATELY!
Smoke alarm sounds Move smoke alarm to a
unwanted alarms when new location. See
residents are cooking or SMOKE ALARM
taking showers. PLACEMENT or replace
with model GC smoke alarm
with False Alarm Control
or model PG-40
photoelectric alarm.
Interconnected smoke Press and hold test
alarms do not sound when button for at least
system is tested. five (5) seconds.
The alarm sounds different The alarm is operating
than I’m used to. It starts and correctly. This alarm features
stops. the internationally recog-
nized horn signal for evacua-
tion. The horn pattern is 3
short beeps followed by a 2
second pause and then
repeats.
Smoke alarm sounds Clean smoke alarm
unwanted alarms at (see page 6).
intermittent times.
Smoke alarm is removed but Something other than the
beeping sound still emits smoke alarm is emitting the
from its ceiling location. beeping.
WARRANTY
Invensys Controls Americas warrants to the original consumer
purchaser each new smoke alarm to be free from defects in
material and workmanship under normal use and service for a
period of five (5) years from date of purchase. Invensys
Controls Americas agrees to repair or replace, at its option,
any defective smoke alarm, provided that it is returned with
postage prepaid and with proof of purchase date to Invensys
Controls Americas. This warranty does not cover damage
resulting from accident, misuse or abuse or lack of reasonable
care of the product. This warranty is in lieu of all other express
warranties, obligations, or liabilities. THE IMPLIED WAR-
RANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE LIMITED TO A PERIOD OF
FIVE (5) YEARS FROM PURCHASE DATE. Some states do
not allow limitations on how long an implied warranty lasts, so
the above limitations may not apply to you. IN NO CASE
SHALL INVENSYS CONTROLS AMERICAS BE LIABLE FOR
ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR
BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS
OR IMPLIED, WHATSOEVER, EVEN IF THE LOSS OR DAM-
AGE IS CAUSED BY ITS NEGLIGENCE OR FAULT. Some
states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion
may not apply to you. This warranty gives you specific legal
rights, and you may also have other legal rights which vary
from state to state.
8
Smoke alarms must be replaced every 10 years. See date
code on back of smoke alarm to determine age.
REPLACE OR RETURN THE ALARM IF THE PUSH-TO-TEST
FUNCTION DOES NOT OPERATE PROPERLY AFTER
FOLLOWING THE PROCEDURES OUTLINED ABOVE (see
REPAIR on page 6).
191 E. North Avenue
Carol Stream, Illinois 60188 USA
www.invensyscontrols.com
©2006 Invensys Controls 110-427K
To Previous Page
Loading...
Need help?
General
