EasyManuals Logo
Home>Firstech>Remote Starter>DC3

Firstech DC3 User Manual

Firstech DC3
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Patent No. US 8,856,780 CA 2759622 DC3 Product Guide
MODULE DIAGNOSTICS - 1 OF 2
MODULE STATUS DURING:
LED 2* LED 1** LED STATUS DIAGNOSTIC
MODULE PROGRAMMING
Flashing RED
Missing/wrong information from fi rmware or vehicle.
See fi rmware specifi c diagnostics, or contact technical support.
Solid RED Module waiting for more vehicle information. Programming incomplete.
Flashing GREEN Additional steps required to complete programming. Refer to install guide.
Solid GREEN then OFF Module programming completed successfully.
o
OFF No activity or module already programmed.
1 RED fl ash No fi rmware on module. Connect to Weblink and fl ash device.
2 ORANGE fl ashes Contact technical support.
3 ORANGE fl ashes Module programming not completed.
4 ORANGE fl ashes Contact technical support.
7 ORANGE fl ashes Contact technical support.
8 ORANGE fl ashes Loop not cut. Ensure loop is cut for automatic transmission. Reset and re-learn.
9 ORANGE fl ashes Loop not cut. Ensure loop is cut for automatic transmission. Reset and re-learn.
10 ORANGE fl ashes Boot loader update failed. Contact technical support.
11 ORANGE fl ashes T-harness detection does not match install type selection in Weblink.
TACH PROGRAMMING
Solid RED Tach learn in progress.
1 GREEN fl ash Tach signal programmed in analog.
2 GREEN fl ashes Tach signal programmed in data.
3 RED fl ashes No tach signal detected
4 RED fl ashes System is in valet mode. Turn off valet mode to program tach.
6 RED fl ashes Engine sensing set for ‘assumed start’. No tach programming required.
7 ORANGE fl ashes Engine sensing not confi gured properly. Contact technical support.
* LED 2 (RS) displays generic diagnostic codes specifi c to the remote start module. Orange LED fl ashes may appear red.
** LED 1 (Bypass) displays diagnostic codes specifi c to the fi rmware loaded on the module.
Visit the programming diagnostics page for more information.
www.idatalink.comAutomotive Data Solutions Inc. © 2022 DC3
PAGE 5 OF 15
• 20220113

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Firstech DC3 and is the answer not in the manual?

Firstech DC3 Specifications

General IconGeneral
BrandFirstech
ModelDC3
CategoryRemote Starter
LanguageEnglish

Related product manuals