34
How to attend to a fault ‐ Classic models
START HERE
Press
to stop the beeping.
Look up the fault code in the
table opposite and note it
down.
U1: Turn on the water supply,
then press
to resume the wash
program.
Press
. Wait a few seconds, then
press
again.
Press
. Another number will
briefly appear in the display. Note
this number down too. It will help
Fisher & Paykel Customer Care
identify the fault more precisely.
U4: Attend to the fault on
the other drawer. The drawer
displaying U4 is not faulty.
YES
NO
NO
NOYES
YES
U6: Open the drawer and check the
spray arm.
Has the spray arm loosened or
come off its mounting?
Water pressure
is too low. You
may need to have
a ‘4 litre’ valve
installed on your
water supply.
Refit the spray
arm following
instructions in section
‘User maintenance
instructions’, then
close the drawer and
press
to resume
the wash program.
If it’s a ‘U’ code
Has the fault code disappeared?
Has the dishwasher resumed
normal operation?
Has the fault code disappeared?
You have corrected the fault
and can continue to use your
dishwasher as normal.
Disconnect the dishwasher from the
power supply (unplug or switch off at
circuit breaker), turn off its water supply,
then contact Customer Care with the
fault code information. See your ‘Service
and warranty’ booklet for contact details.
The fault has
reset. You can
continue to use
your dishwasher.
If it’s an ‘E’ code
To Next Page
Loading...
Need help?
General
