4. Solder the 9-Pin jack to the system
A prewired output cable from the Powerchip is to be soldered to the provided
9-Pin Jack. Prepare the jack by soldering a jumper wire between the sleeve
terminal,located on the business end of the jack, and terminal #2, directly
below.
Solder the jac
k as follows:
a. Solder the shield from the output cable to terminal #2.
b. Solder the red wire from the output cable to terminal #4.
c. Solder the white wire from the output cable the terminal #8.
d. Solder the black battery wire (negative) to terminal #1.
Piezo/Magnetic Outboard Mixing Preamp
9
To Next Page
Loading...
Need help?
General