FLIR ONE Edge Series User Manual

2 EN-US English
6. Extending arm
2.8 Quick start guide
1. Install the FLIR ONE app, developed by FLIR Systems, from your preferred
app store.
2. Attach the FLIR ONE Edge camera to the back of your mobile device by pull-
ing out the extending arm until the camera is clamped around the device. As
an alternative, place the FLIR ONE Edge camera close to your mobile device.
Note To prevent damage to the equipment, avoid extending the arm to its
end position.
3. To turn on the FLIR ONE Edge camera, press and hold the On/Off button un-
til the LEDs start flashing, indicating that the camera is booting up. It takes
about 20 seconds for the camera to start.
4. Start the FLIR ONE app on your mobile device.
5. The FLIR ONE app will guide you to set up the app according to your prefer-
ences and to connect (pair) the camera with your mobile device.
6. To turn off the FLIR ONE Edge camera, press and hold the On/Off button un-
til the LEDs turn off.
#T810602; r. AB/88817/88817; mul 4

FLIR ONE Edge Series Specifications

General

Brand	FLIR
Model	ONE Edge Series
Category	Thermal cameras
Language	English