Poly/Foam Pad
Remove mechanical frame from the filter body
and place in an empty bucket. Remove Poly/
Foam Pad from frame, and rinse using water
taken from the aquarium. Do not use tap
water as this will kill the beneficial bacteria
in your foam. NEVER use soap or detergents
as these products could be harmful to the
inhabitants of your aquarium. After rinsing,
reinstall the Poly/Foam Pad into the mechani-
cal frame, then slide the frame into the rear
the of filter case with the cleaning indicator to
the right. Note: Make sure that the dense
polyester side is facing the grid on the frame.
For best results, replace every 4-6 weeks.
Activated Carbon Insert
Remove filter cover. Pull out
the chemical basket and
Trickle Chamber from filter
body. Separate the 2 sections,
then remove insert from
Chemical basket. Replace
with new insert. For best
results, replace every 2-4
weeks.
Bio-Screen
Remove filter cover. Using the tab, pull open the Trickle Chamber Cover and remove it. Place cover in the
sink or a bucket, and rinse with the Bio-Screen, using water taken from the aquarium. Do not use tap
water as this will kill the beneficial bacteria in your foam. For best results, replace every two to
three months.
To Next Page
Loading...
Need help?
General
