Q
R
Cleat
Cut out area
of spool
Eyelet
Fault Finding Chart (Automatic Line Feed only)
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT CHECK ACTION
Is the automatic line feed work-
ing?
Manually feed out line.
Is the line fed out and visible?
Has line been removed from
cleat?
Remove cap and spool, free line
and re-fit spool and cap.
The line may be jammed on the
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Is the manual line feed working?
Has too much line been fed out? Rewind line.
Contact your local approved Service
Centre or Husqvarna UK Ltd. Customer
Service.
Is the line cutter missing from the
safety guard?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558 UK 1800 882 350 ROI
No
No
No
Yes
Yes
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT P ERSISTS
Has the motor reached full speed
before use?
No
Allow the motor to reach full speed
before use
Are you using the trimmer cor-
rectly?
?
Only use tip of nylon line to trim.
Is the line jamming on the spool?
Yes
Rewind the line on the spool, if
symptoms still persist, change
spool and line.
Replacement Parts
Spool and Line
Reference no.: FLY031
Part no.: 513106090
To fit spool and line complete:
1. Remove old spool.
2. Place new spool into spoolholder with cut out areas of
the spool in line with eyelets
as shown in figure Q.
3. Release one line from cleat and feed line through eyelet (Q).
4. Repeat for second line.
• Ensure spool is fully located by gently rotating it during fit-
ment, whilst keeping the spoolholder steady.
5. Refit the cap.
To fit nylon line only:
• Remember! Your Trimmer is designed to use only nylon
line with a maximum diameter of 1.5mm
. Use only gen-
uine Husqvarna UK Ltd. nylon line.
1. IMPORTANT - Always wind the line onto the upper sec-
tion of the spool first.
Take approximately 5 metres of line. Insert 15mm of line
into one of the holes in the upper section of the spool (R)
and wind line in the direction of the arrows on the top of
the spool. Leave approximately 100mm of line unwound
and place into cleat as illustrated in figure R. Repeat on
lower section of spool.
2. Care should be taken to ensure that the line is neatly
coiled on the spool. Failure to do so will impair the effi-
ciency of the automatic line feed.
3. Then fit spool as described in ‘To fit spool and line com-
plete’, section above.
•Always return the product to its normal operating position
before switching on.
To Next Page
Loading...
Need help?
General