Flymo Vision User Manual

5
Grassbox Full
• As the grassbox fills up, grass will be clearly visible
through the window in the lid (N).
• When the window is full it is time to empty the grass-
box.
Emptying the Grassbox
• Stop the lawnmower, as described in ‘To Stop
your Lawnmower’ and wait until the blade has
stopped rotating, BEFORE lifting the grassbox lid.
1. Lift the grassbox lid and rest against the handles (P).
2. Remove the grassbox using the moulded handle
recesses as illustrated.(See Figure Q).
3. Empty grassbox.
4 Replace grassbox and lid carefully.
• Failure to fit the grassbox and grassbox lid cor-
rectly will cause poor collection of grass clip-
pings.
Removing and fitting the Blade and Fan
N
P
;;;;
;;;;
;;;;
Q
grassbox is full
grassbox is
empty
M
blade bolt
blade
fan
spacers
Caring for your Lawnmower
Cleaning
IMPORTANT: It is very important that you keep your lawn-
mower clean. Grass clippings left in any of the air intakes or
under the hood could become a potential fire hazard.
USE GLOVES
It is recommended that you clean your lawnmower
straight after mowing while the grass is still wet.
1. Remove grass from under the hood with the span-
ner/scraper tool. (R)
2. Remove the blade, see Figure L, to gain access to
the fan and clean with a soft brush. (R)
3. Lever the roller out of position and clean with a soft
brush. (R)
R
Removing, Emptying and Refitting the Grassbox
Removing the Blade and Fan
1. To remove the blade bolt, hold the fan firmly and
with the spanner provided loosen the blade bolt by
turning it anti-clockwise (L).
2. Remove the blade bolt, blade, spacers and fan.
(M)
3. Inspect for damage and clean as necessary.
• Renew your metal blade after 50 hours mowing
or 2 years whichever is the sooner - regardless
of condition.
• If the blade is cracked or damaged replace it
with a new one.
• Never use a blade bolt if the insulated head is
damaged cracked or missing.
Fitting the Blade and Fan
1. Ensure the fan is located correctly.(L)
2. Place the spacers onto the fan ensuring the pegs
have located into the holes.(L)
3. Place the blade onto the spacers ensuring the pegs
have located into the holes on the blade and ensuring
the blades is positioned as illustrated in Figure L.
4. Place the blade bolt through the centre hole of the blade.
5. Tighten down clockwise by hand.
6. Hold the fan firmly and tighten the blade bolt with
the spanner provided.

Flymo Vision Specifications

General

Brand	Flymo
Model	Vision
Category	Lawn Mower
Language	English