8 - MAINS POWER CONNECTOR
Plug the supplied power cord into this connector.
9 - WALL OR CEILING MOUNTING
The attachment points enable you to mount your Shape studio monitors to the wall or to the ceiling.
The Shape 40 studio monitor is supplied with a plate so that it can be used with K&M® accessories.
The centre-to-centre distance is 2
3/4
" (70 mm) for the Shape 40, 50, 65 and Twin. Use M6 screws.
10 - MOUNTING TO A TABLE STAND OR A MICROPHONE STAND
The fastening point underneath the Shape 40 and Shape 50 is for mounting the loudspeaker to a table stand or a
microphone stand.
The format required is BSW 3/8”.
11 - LED ON THE FRONT PANEL
The LED on the front panel is off when the loudspeaker is set to OFF. When the ON/OFF switch is flipped from OFF
to ON, the LED lights up green. When an audio signal is detected, the loudspeaker switches from 'Standby' to 'On'
and the LED lights up green. After approximately 30 minutes without detecting an audio signal, the loudspeaker
automatically switches to 'Standby' to avoid unnecessary power consumption and the LED lights up red. In
'Standby' mode, power consumption is less than 0.5 W. To exit this mode, send an audio signal to the loudspeaker.
It takes a few seconds for the loudspeaker to switch from 'Standby' to 'On'.
See the diagram below for more information on fixing mechanisms.
See the table below for references of compatible K&M® products.
Wall mount Ceiling mount
Table stand / microphone
stand
Shape 40 Fixing kit K&M® 24471 Fixing kit K&M® 24496 Fixing kit K&M® 232
Shape 50
Fixing kit K&M® 24471
+ K&M® 24359 adapter
Fixing kit K&M® 24496
+ K&M® 24359 adapter
Fixing kit K&M® 232
Shape 65
Fixing kit K&M® 24471
+ K&M® 24357 adapter
Fixing kit K&M® 24496
+ K&M® 24357 adapter
-
Shape TWIN
Fixing kit K&M® 24471
+ K&M® 24357 adapter
Fixing kit K&M® 24496
+ K&M® 24357 adapter
-
User Manual
To Next Page
Loading...
Need help?
General
