To Next Page

To Previous Page

1. Turn the ignition switch to the on position. DO NOT START THE

ENGINE.

2. Wait until the safety belt warning light turns off (Approximately

1 minute).

• Step 3 must be completed within 30 seconds after the safety belt

warning light turns off.

3. For the seating position being disabled, buckle then unbuckle the

safety belt three times at a moderate speed, ending in the unbuckled

state.

• After Step 3, the safety belt warning light will be turned on for three

seconds.

4. Within approximately seven seconds of the light turning off, buckle

then unbuckle the safety belt.

• This will disable the Belt-Minder威 feature for that seating position if it

is currently enabled. As confirmation, the safety belt warning light will

flash four times per second for three seconds.

• This will enable the Belt-Minder威 feature for that seating position if it

is currently disabled. As confirmation, the safety belt warning light will

flash four times per second for three seconds, followed by three

seconds with the light off, then followed by the safety belt warning

light flashing four times per second for three seconds again.

• After receiving confirmation, the deactivation/activation procedure is

complete.

AIRBAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)

4X4

Seating and Safety Restraints

140

2010 Escape Hybrid (ehv)

Owners Guide, 1st Printing

USA (fus)

Ford 2010 Escape Hybrid Owner's Guide

Other manuals for Ford 2010 Escape Hybrid