INFORMATION DISPLAY
CONTROL
AUTOWIPERS
High sensitivityA
OnB
Low sensitivityC
Use the rotary control to adjust the
sensitivity of the autowipers. When you
select low sensitivity, the wipers will
operate when the sensor detects a large
amount of water on the windshield. When
you select high sensitivity, the wipers will
operate when the sensor detects a small
amount of water on the windshield.
AUTOLAMPS
The headlamps will switch on and off
automatically in low light situations or
during inclement weather.
Note: You may have to manually switch the
headlamps on in severe weather conditions.
HEADLAMP EXIT DELAY
After you switch the ignition off, you can
switch the headlamps on by pulling the
direction indicator lever toward you. You
will hear a short tone. The headlamps will
switch off automatically after three minutes
with any door open or 30 seconds after the
last door has been closed. You can cancel
this feature by pulling the direction indicator
toward you again or switching the ignition
on.
TRIP COMPUTER
Resetting the Trip Computer
Press and hold OK on the current screen to
reset the respective trip, distance, time and
average fuel information.
Trip Odometer
Registers the distance traveled of individual
journeys.
Distance to Empty
Indicates the approximate distance your
vehicle will travel on the fuel remaining in
the tank. Changes in driving pattern may
cause the value to vary.
5
Tourneo Custom/Transit Custom (TTF) Vehicles Built From: 26-06-2014, Vehicles Built Up To: 15-03-2015, EK2J-19G217-AKA (CG3580en) enGBR, Edition date: 04/2014, First Printing
To Next Page
Loading...
Need help?
General
