7
Programming a Thermostat with a Network Programmer
In case of Network Installation with Remote Management, the thermostat must
be programmed with a Network Programmer specic to the property before the
installation.
Thermostat must not be powered during the pairing procedure..
➤ Plug one programmer connector into the thermostat;
➤ Push the black button on the programmer. The red light on the programmer
should turn on and remain steadily lit;
If the red light on the programmer is blinking or is not steadily lit, unplug the
programmer from the thermostat and repeat the steps above.
➤ Unplug the programmer from the thermostat;
Before You Begin
To Next Page
Loading...
Need help?
General
