Cleaning & Use Guidance：
1. Clean the inner liner, ice collecting tray, water box, ice shovel and
evaporator frequently. When cleaning, unplug the unit and remove the ice
cubes. Use a diluted solution of water and vinegar to clean the inside and
the outside surface of the Ice maker. Do not spray Ice maker with
chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly
before starting.
2. Keep ventilation openings in the appliance enclosure, or in the built-in
structure, clear of obstruction. Do not use mechanical devices or other
means to accelerate the defrosting process, other than those
recommended by the manufacturer.
3. To ensure the cleanness of ice, please change water for water reservoir at
least once one day. If do not use for a long time, please drain the water out
and clean it up.
4. If the compressor takes a strike action for shortage water, fully water or
interruption of power supply, it will delay for 3 minutes to start up after
restarted.
5. Always use fresh water before starting ice production either at initial
installation or after a long shut-off period.
6. In the status of standby, press and hold the key for 3 sec into cleaning
after 5 minutes done.
7. Disassembling the water hose to clean when it is dirty or the hole is
blocking.
Troubleshooting：
Please note, if a power failure occurs due to disconnection of the power cord,
or the power button has been pushed off during an ice making cycle, small ice
chips may formed and lodge in the automatic shovel causing it to jam. If this
To Next Page
Loading...
Need help?
General
