Operating Instructions
Operating Instructions
4
2009 Electrolux Home Products, Inc. All rights reserved.
Allow the unit to reach room temperature before operating.
To begin operating the dehumidifier, follow these steps:
1. Plug the power cord into a properly grounded 115 volt AC outlet.
If the "BUCKET FULL" light is on, remove the bucket and re-install to reset the float switch.
NOTE:
Unit must be upright for one hour prior to operating.
NOTE:
2. To turn the unit on, press the ON/OFF button. The unit will run in the factory setting of CONTINUOUS and high fan
speed. In the CONTINUOUS mode, the unit will only display CO and not the room humidity. It is recommended you
leave the unit running in the CONTINUOUS setting for the first three or four days until the sweating and dampness
odors have stopped.
To Next Page
Loading...
Need help?
General
