1
Washer Tech Data Sheet
This information is intended for Qualified Technicians Only.
CAUTION: DISCONNECT ELECTRICAL CURRENT BEFORE SERVICING
Please Return This Sheet to its Envelope in the Product for Future Reference
Contents Page
Error code explanation.........................................1
Diagnostics...........................................................2
Error Code Chart...................................................3
Tests.......................................................................4-5
Français...................................................................6-10
Español.....................................................................11-15
Wiring Diagram.........................................................16
READING ERROR CODES:
1. Wake the washer by pressing any button.
2. Wait 5 seconds.
3. Press and
HOLD the Start/Pause and Cancel buttons simultaneously. As long as the buttons are held, the
failure code will appear in the display as an E followed by two numbers, a number and a letter or two letters.
The control will beep.
Troubleshoot the problem by using charts on the pages 3-5.
NOTE: During normal operation, the display may show:
“cd” - cool down (Sanitary cycle)
“do” or “dr” - door problem.
“Err” - an error has been detected.
“LOC” - control lock is activated.
“PAU” - cycle has been interrupted.
To clear latest stored error code:
• Turn the Program Knob to the
start position of the cycle furthest to the left
• Press Start/Pause to start the cycle and save it.
• Press Cancel to stop the cycle and turn off the LEDs.
• Press any button (except the cancel button) to wake up the control.
• Within 5 seconds, press and hold the Option and Start/Pause buttons until LEDs start sequentially chasing,
then release buttons.
• Turn the program knob clockwise 7 clicks from the Start Position. The control will signal the last error code.
• Press and hold the Options and Start/Pause buttons for 3 seconds. The code will be cleared.
• Exit Diagnostic Mode to return the washer to normal operation.
a) Unplug the power cord, wait 5-8 seconds, then reconnect the power cord OR
b) Turn the program knob clockwise 2 or 3 clicks after the Start Position. Press Options and Start/Pause
buttons together for a few seconds until wash cycle LEDs appear.
137312800A (1003)
To Next Page
Need help?
General
