Frigidaire FFBD1821MW User Manual

11
Installation Instructions
STEP 14 PRE-TEST CHECKLIST
Review this list after installing your
dishwasher to avoid charges for a service
call that is not covered by your warranty.
¨ Check to be sure power is OFF.
¨ Open door and remove all foam and paper
packaging.
¨ Locate the Owner’s Manual in the literature package.
¨ Read the Owner’s Manual for operating instructions.
¨ Check door opening and closing. If door does not
open and close freely or tends to fall, check spring
adjustments. See Step 1.
¨ Check to be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components. See Step 9.
¨ Check door alignment with tub. If door hits tub, level
dishwasher. See Step 10.
¨ Pull lower rack out, about half way. Check to be sure
it does not roll back or forward on the door. If the
rack moves, adjust leveling legs. See Step 10.
¨ Check door alignment with cabinet. If door hits
cabinet, reposition or relevel dishwasher. See Step
10.
¨ Verify water supply and drain lines are not kinked or
in contact with other components. Contact with
motor or dishwasher frame could cause noise. See
Step 8.
¨ Turn on the sink hot water faucet and verify water
temperature. Incoming water temperature must be
between 120°F and 150°F. A minimum of 120°F
temperature is required for best wash performance.
See "Prepare Hot Water Line", page 5.
¨ Add 2 quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
¨ Turn on water supply. Check for leaks. Tighten
connections if needed.
¨ Remove protective film if present from the control
panel and door.
STEP 13 CONNECT POWER
SUPPLY
Skip this step if equipped with power cord.
Verify that power is turned off at the source.
• Remove junction box cover “A”.
• Locate the three dishwasher wires, (white, black and
green) with stripped ends. Insert dishwasher wires
through the small hole in the junction box “B”.
• Secure house wiring to the bottom of the junction box
with a strain relief “C”.
• User wire nuts to connect incoming ground to green,
white to white and black to black “D”.
• Replace junction box cover “E”. Check to be sure
that wires are not pinched under the cover.
WARNING
If house wiring is not 2-wire with
ground, a ground must be provided
by the installer. When house wiring
is aluminum, be sure to use UL
Listed anti-oxidant compound and
aluminum-to-copper connectors.

Frigidaire FFBD1821MW Specifications

General

Style	built-in dishwashers
Color	white
Load Capacity	12
Noise level	55 decibels
Control Type	electronic
Delay Start	yes
Number of Racks	2
Cycle Signal	no
Food Disposer	no
Sanitize Settings	no
Annual Energy Consumption	280 kilowatt hours
Water Consumption Per Cycle	4 gallons
Voltage	120 volts
Current	8.5 amperes

Weight and Dimensions

Depth	23 inches
Height	34.875 inches
Width	17.625 inches
Net Weight	65 pounds