1=800=944=9044 (United States) ]
1=800=265=8352 (Canada)
1
Visit our web site at
www.frigidaire.com
CONCERN CAUSE SOLUTION
AUTOMATIC ICE MAKER
• Ice maker is turned off. • Turn on ice maker. For the fresh food iceIce maker is
not making any
ice,
• Refrigerator is not
connected to water line
or water valve is not
open.
The water supply line is
kinked.
The water filter is not
seated properly.
• The water filter may be
clogged with foreign
material.
Ice maker is
not making
• Freezer ice maker wire
signal arm is being
held up by an item not
allowing it to go in the on
or down position.
® Ice maker is producing
less ice than you expect.
maker, press and hold the "Ice Off" button
for three seconds until the indicator light
is off. For the freezer ice maker, lower the
wire signal arm.
Connect the unit to the household water
supply and ensure the water valve is open.
• Ensure that the supply line does not kink
when the refrigerator is pushed into place
against the wall.
• Remove and re-install the water filter. Be
sure to push the filter firmly so that you
hear it lock solidly into position.
• If water dispenses slowly or not at all, or
if the filter is six months old or older, it
should be replaced.
• Move any item or frozen ice cubes that
may block the signal arm from being in the
on or down position. See Automatic Ice
Maker-Freezer section in manual.
• The fresh food and freezer ice makers will
each produce approximately 2.5 pounds
enough ice. , of ice every 24 hours depending on usage
I I condtons.
• The water filter may be ." If water dispenses slower than normal,
. clogged with foreign or if the filter is six months old or older, it
I material. . should be replaced.
® The water supply line is , Ensure that the supply line does not kink
kinked, when the refrigerator is pushed into place
I against the wall.
I® Saddle valve on cold '- Turn off household water line valve.
I water pipe is clogged Remove valve. Ensure that valve s not
or restricted by foreign I a self-pierdng saddle valve. Clean valve.
material. I Replace valve if necessary.
• Heavy traffic, opening ® Press Fast Freeze to temporarily increase
or closing of the doors ice production rate.
excessively. I
i Freezer control is set too • Set freezer control to colder setting to
warm (freezer ice maker), improve performance of the ice maker
_ (freezer ice maker). Allow 24 hours for
temperature to stabilize.