FS PoE+ Series User Manual

www.fs.com
1
1. Configuration Preparation
This document provides the information that you need when configures your switch for the first time, including the port number,
necessary procedures before the switch is started up and introduction of Command-Line interface.
• Switch Port Number
• Before Starting up Switch
• Help
• Command Mode
• Canceling the Command
• Saving the Settings
1.1 Switch Port Number
Switch physical port number are formatted as <type><slot>/<port>, types and names of which are listed in the following
comparison table:
Interface Type Purpose Purpose
10M Ethernet Ethernet e
100M fast Ethernet FastEthernet f
1000M Ethernet GigaEthernet g
The expansion slot number in standard configuration is always 0. The others begin at 1 and continue from left to right.
Ports number in the same expansion slot is numbered from bottom to top and from left to right, starting with 1. If only one port exits,
it is numbered 1.
Note:
Ports in modules are numbered orderly from bottom to top and from left to right.
1.2 Before Starting Up Switch
Before configuring after turning on the switch, please confirm the following steps:
(1) Setup Switch Hardware following the manual.
(2) Configure the PC Terminal Emulation procedure.
(3) Making a IP address planning first as per IP network protocol.
1.3 Help
By a question mark (?) or direction keys, you can obtain the associated information for any command:
• The currently available command list can be presented if you enter a question mark.
Switch> ?
• The currently available commands starting with the known characters in the list can be displayed if you enter the known
characters and then a question mark (without space).
Switch> s?
• The parameter list of a command will be obtained if you enter the command, press "Space" and enter the question mark.
Switch# show ?
• The previously entered commands can be presented if you press the “up” arrow key. If you continue press the “up” arrow key,
more commands can be shown. If you press the “up” arrow key and then the “down” arrow key, the next command line
following the current one can be presented.
1.4 Command Mode
The window for the switch’s command line can be in multiple modes: Each command mode allows you to set a different suite on a
switch, while the presently available commands are up to your current command mode. Input a question mark to list all commands
available for current command mode. The following table shows frequent command modes:
POE+ SERIES SWITCHES CON
FIGURATION PREPARATION GUIDE

FS PoE+ Series Specifications

General

Brand	FS
Model	PoE+ Series
Category	Switch
Language	English