To Next Page

To Previous Page

Conguring the Switch

Step 1: Connect the computer to any Ethernet port of the switch using the network cable.

Step 2: Set the IP address of the computer to 192.168.1.x. ("x" is any number from 2 to 254.). Set the

subnet mask of the computer to 255.255.255.0.

Conguring the Switch Using the Web-based Interface

Cancel

General

IP address:

Subnet mask:

Default gateway:

You can get IP settings assigned automatically if your network

supports this capability. Otherwise, you need to ask your network

administrator for the appropriate IP settings.

Internet Protocol Version 4 (TCP/IPv4) Properties

Use the following IP address:

Obtain an IP address automatically

Preferred DNS server:

Alternate DNS server:

Validate settings upon exit

Advanced...

. . .

21168192

0255

255255

. . .

Obtain DNS server address automatically

Use the following DNS server addresses:

Step 3: Open a browser, type http://192.168.1.1, and enter the default username and password,

admin/admin.

Step 4: Click sign in to display the web-based conguration page.

Step 1: Connect a computer to the switch's console port using the supplied console cable.

Step 2: Start the terminal simulation software such as HyperTerminal on the computer.

Step 3: Set the parameters of the HyperTerminal: 115200 bits per second, 8 data bits, no parity, 1 stop

bit and no ow control.

Conguring the Switch Using the Console Port

FS STP Series User Manual

Other manuals for FS STP Series