To Next Page

To Previous Page

- 9 -EN

Connecting to the SFP+ Port

1. Insert an SFP+ transceiver into the SFP+ slot.

2. Connect a ber optic cable to the SFP+ transceiver. Plug the other

end of the ber optic cable to the ber network. TX and RX must be

paired at both ends.

NOTE:

Both multimode and single mode cablings are

supported. Make sure both side of the SFP+ transceivers are

with the same media type.

SFP



LOOP

SFP



PWR

FX/LNK

UMC-2S

10GBASE-X to 10GBASE-X

Unmanaged 10G Fiber Media Converter

Questions and Answers:

Need help?

Do you have a question about the FS UMC-2S and is the answer not in the manual?

FS UMC-2S Specifications

General