Fujitsu Air Conditioner Compact Wall Mounted Type User Manual

PREPARATION
CAUTION!
●
Take care to prevent infants from acciden-
tally swallowing batteries.
●
When not using the Remote Controller for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
●
If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
●
Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
●
Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller's
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
Load Batteries (Size AAA R03/LR03

2) *
1
Press and slide the battery compartment lid on the
reverse side to open it.
Slide in the direction of the arrow while pressing the mark.
* Batteries are not included with this product.
2
Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3
Close the battery compartment lid.
Set the Current time
1
Press the CLOCK ADJUST button (Fig. 5
P
).
Use the tip of a ball-point pen or other small object to press the button.
2
Use the TIMER SET ( / ) buttons (Fig. 5
O
) to
adjust the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in 1
minute increments; hold the buttons depressed to change the time quickly in
10 minute increments.)
3
Press the CLOCK ADJUST button (Fig. 5
P
) again.
This completes the time setting and starts the clock.
To Use the Remote Controller
●
The Remote Controller must be pointed at signal receiver (Fig. 3
4
) to operate cor-
rectly.
●
Operating Range: About 7 meters.
●
When a signal is properly received by the indoor unit, a beeping sound will be heard.
●
If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
3 To remove the Remote
Controller (when use at hand).
1 Mount the Holder. 2 Set the Remote Controller.
Screws
Insert
Press in
Slide up
Pull out
Turn on the Power
1
Turn on the circuit breaker
En-5
9332280029-04_OM.indb Sec1:59332280029-04_OM.indb Sec1:5 2/25/2013 3:27:50 PM2/25/2013 3:27:50 PM

Fujitsu Air Conditioner Compact Wall Mounted Type Specifications

General

Brand	Fujitsu
Model	Air Conditioner Compact Wall Mounted Type
Category	Air Conditioner
Language	English