Fujitsu AOU18RD User Manual

NAME OF PARTS
— Fig. 1 Indoor Unit-
-© Operating Control Panel (Fig. 2)-
(D MANUAL AUTO button _
© Remote Control Signal Receiver
-® Indicator Lamps (Fig. 3)-
© OPERATION Indicator Lamp (red)
© TIMER Indicator Lamp (green)
• If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(see page 17 Auto Restart).
© SWING indicator Lamp (orange)
© intake Grille (Fig. 4)
® Air Filter
© Air Flow Direction Louver
© Right-Left Louvers
(behind Air Flow Direction Louver)
© Drain Hose
© Inter Unit-Line
© Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit —
© Power Supply
© Intake Port
© Outlet Port
© Pipe Unit
® Drain port (bottom)
- Fig. 6 Remote Control Unit-—
© SLEEP button
© MASTER CONTROL button
@ SET TEMP./SET TIME button (©/©)
© Signal Transmitter
© TIMER button
© FAN CONTROL button
© START/STOP button
© AIR FLOW DIRECTION button
© SWING LOUVER button
-Rear side (Fig. 7)-
© TIME ADJUST button
© ACL button
(located inside battery compartment)
® TEST RUN button
• This button is used when installing the
unit, and should not be used under nor¬
mal conditions, as it will cause the air con¬
ditioner's thermostat function to operate
incorrectly.
• If this button is pressed during normal op¬
eration, the unit will switch to test opera¬
tion mode, and the Indoor Unit's OPERA¬
TION Indicator Lamp and TIMER Indicator
Lamp will begin to flash simultaneously.
• To stop the test operation mode, press the
START/STOP button to stop the air condi¬
tioner.
-© Remote Control Unit Display (Fig. 8)
© Transmit Indicator
© Clock Display
© Operating Mode Display
® Timer Mode Display
© Fan Speed Display
© Temperature Set Display
© Timer Set Indicator
© Temperature Set Indicator_
En-5

Fujitsu AOU18RD Specifications

General

Brand	Fujitsu
Model	AOU18RD
Category	Air Conditioner
Language	English