Important notes
• The device may only be operated in wide format (0° landscape mode) and high format
(90° portrait mode). The buttons of the control panel are located at the bottom in
the middle of the monitor in wide format (0° landscape mode) and at the left-hand
side of the monitor in high format (90° portrait mode).
• Store this manual close to the device. If you pass the device on to third
parties, you should pass this manual on with it.
• We recommend that you place your device on a durable, non-slip surfa ce. In view
of the many different finishes and varnishes used on furniture, it is possible that the
feet of the device may mark the surface they stand on.
• The device must be connected to protect ive earth.
• To prevent possible hearing da m age, do not listen at high volume levels for long pe riods.
• Warning for excessive sound pressure from earphones and headph ones:
Excessive sound pressure from earphones and headphones can cause hearing loss.
Adjustment of the equalizer to maximum increases the earphones and hea dphones
output voltage and therefore the sound pressure level.
Power cable
Use the supplied power cable only.
Use the following guidelines if it is necessary to replace the original cable set.
• The female/male recep tacles of the cord set must meet I EC 60320/C E E-22 requirements.
• The cable has to be HAR-certified or VDE-certified. The mark HAR or
VDE will appear on the outer sheath.
• For devices which are mounted on a de sk or table, type SVT or SJT cable sets may be
used. For de vices which sit on the floor, only SJT type cable sets may be used.
• The cable set must be selected according to the rated current for your device.
• If necessary, replace the original power cable with a regular grounded 3-core ma ins lead.
Transporting the device
Device,Transpo rtationRetransportation
Transport all parts sep arately in their original packaging or in a packaging which
protects them from knocks and jolts, to the new site.
Do not unpack them until all transportation manoeuvres are completed.
If the device is brought from a co ld environment into the room where it will be used,
condensation may occur. Before ope rating the device, wait until it is absolutely dry
and has reached approximately the same temperature as the insta llation site.
8 Fujitsu
To Next Page
Loading...
Need help?
General