Operation
Function Description
V-position
Adjusting the picture vertical position
With this funct ion you move the picture up or down.
This setting only appears with an analogue video signal (e.g. VGA).
Auto adjust
Perform auto-adjustment of the monitor
With this function, the m on itor automatically sets the analogue parameters.
► Press the
button to run th
e function.
The Auto Processing messag e appears.
This setting only appears with an analogue video signal (e.g. VGA).
Sharpness
Setting the picture sharpness
This function is used to confi gure the integrated soft focus or sharpness
filter of the monitor.
• Values below 50 produce a softer picture.
• Values above 50 produce a sharp er picture.
Saturation
Setting colour saturation
You can use this function to reduce or increase the intensity of the colours.
This setting only applies for devices with YUV output (e.g. BluRay players).
Hue
Setting the col
our tone
This function
can be used to shift the colour spectrum in order to compensate
for a colour fa
ult that may be present.
This se tting
only applies for devices with YUV output (e.g. BluRay players).
Expansion
Adjusting s
ize
This functi
on is used to change the type of scaling of low resolutions.
Full scree
n = maximum picture s ize with distortion (no black bands)
Keep aspe
ct = M a ximum picture size without distortion (black bands could
appear in
one direction)
1:1 = Cent
red image without scaling (black bands could a ppear in both
directi
ons). This function is not available on all models.
22 Fujitsu
To Next Page
Loading...
Need help?
General