Fujitsu Primergy RX100 S3 Start Guide

2
4
Checking location before installing the server
For details on installing the rack, refer to the "Rack Instal-
lation Guide" and the manual provided with the rack.
n
Conditions
When installing this server avoid the following areas.
- Humid, dusty, or oily areas
- Poorly ventilated areas
- Areas close to re or other sources of heat
- Areas close to water
- Areas close to direct sunlight or near heating appliances
- Areas with a temperature of below 10°C or above 35°C
- Areas with humidity of less than 20% or more than 80%
- Salty areas
- Areas where corrosive gas is generated
- Areas where cables become trip hazards
- Areas where strong magnetic elds are generated, such
as near TVs and speakers
- Areas where the server is not stable and could tip over
and hurt somebody
- In dusty areas, dust will stick to the front and backside of
the server for a short period of time.
Since it causes failure, changing the installation place is
recommended.
- Noise levels of this server are measured at 51.5dB(A).
When the server is installed to e.g. an ofce use the
server with careful consideration to the environment.
- Be sure to x the rack and attach stabilizers to the base
of the rack.
n
Installing the server to the rack
1
Open both the front and rear doors of
the rack.
2
Attach M5 rack nuts to the rack.
Insert the rack nut’s in the rack’s 2nd hole position.
(counting up from the base of the server).
3
Pull out the inner rail from the slide
rail.
Pull out the inner rail pushing the lock on the far
side.




4
Attach the inner rails on the right and
left side of the server.

5
Insert the tags of the slide rail to the
second hole from the bottom of the
server.










Fujitsu Primergy RX100 S3 Specifications

General

Brand	Fujitsu
Model	Primergy RX100 S3
Category	Server
Language	English