Fusion EL Series User Manual

Dimension Drawings
Side View
40 mm (1
37
/
64
in.)
127 mm (5 in.)
A Sports model speaker is shown, but the dimensions are the
same for the Classic model.
Front View
176 mm (6
15
/
16
in.)
A Sports model speaker is shown, but the dimensions are the
same for the Classic model.
Back View
176 mm (6
15
/
16
in.)
156 mm (6
1
/
8
in.)
Cleaning the Speakers
NOTE: When mounted correctly, these speakers are rated IP65
for protection in the harsh marine environment from the front of
the speaker. They are not designed to withstand high pressure
water spray, which may occur when you wash down your
vessel. Failure to carefully spray-clean the vessel may damage
the product and void the warranty.
NOTICE
Do not use harsh or solvent-based cleaners on the speakers.
Using such cleaners may damage the product and void the
warranty.
1
Clean all salt water and salt residue from the speaker grille
with a damp cloth soaked in fresh water.
2
Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the speakers
• Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.
The system lacks bass or high frequencies
• Verify that the correct wire polarity is observed between the
source and speakers.
The wires should be connected positive to positive and
negative to negative.
• Verify that the speakers are attached firmly to the mounting
surface.
The audio is distorted
• Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
• Verify that the panels surrounding the speaker on the vessel
are not rattling.
• Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
• If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
The LED lights will not turn on
• Verify that all wiring connections are correct and tight.
Specifications
Max. power (Watts) 80 W
RMS power (Watts) 20 W
Efficiency (1 W/1 m) 88 dB
Frequency response (+ 3 dB) 45 Hz to 16 kHz
Min. mounting depth (clearance) 43 mm (1
11
/
16
in.)
Mounting diameter (clearance) 130 mm (5
1
/
8
in.)
Impedance 4 ohm
Amplifier power-rating
recommendation
From 20 to 40 W RMS, playing
music
EL Series Installation Instructions 3

Fusion EL Series Specifications

General

Brand	Fusion
Model	EL Series
Category	Speakers
Language	English