9
trouble shooting
Before going through the checklist, check wiring connection. If any of the problems persist after checklist
has been made, consult your nearest service dealer.
symptom cause solution
No power. The ignition switch is not on. If the power supply is
connected to the accessory
circuits, but the engine is not
moving, switch the ignition
key to “ACC”.
The fuse is blown. Replace the fuse.
Disc cannot be loaded Presence of CD disc inside Eject the disc in the player,
or ejected. the player. then insert the next.
Inserting the disc in reverse Insert the compact disc with
direction. the label facing upward.
Compact disc is extremely Clean the disc or try to play
dirty or defective disc. a new one.
Temperature inside the ship Cool off or until the ambient
Is too high. temperature return to normal.
Condensation. Leave the player off for an
hour or so, then try again.
No sound. Volume is in minimum. Adjust volume to a desired level.
Wiring is not properly Check wiring connection.
connected.
Sound skips. The installation angle is more Adjust the installation angle
than 30 degree. less than 30 degree.
The disc is extremely dirty or Clean the compact disc, then
it is a defective disc. try to play a new one.
The operation keys do not The built-in microcomputer Press the RESET button….
work is not operating properly due front panel is not properly fix
to noise. into its place.
The radio does not work. The antenna cable is not Insert the antenna cable firmly.
The station automatic connected.
selection does not work.
The signals are too weak. Select a station manually.
To Next Page
Loading...
Need help?
General
