EasyManuals Logo
Home>Fusion>Speakers>SG-TW10

Fusion SG-TW10 User Manual

Fusion SG-TW10
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
NOTICE
Do not use harsh or solvent-based cleaners on the speakers.
Using such cleaners may damage the product and void the
warranty.
1
Clean all salt water and salt residue from the speaker grille
with a damp cloth soaked in fresh water.
2
Use a mild detergent to remove a heavy buildup of salt or
stains.
Troubleshooting
Before you contact your FUSION dealer or service center, you
should perform a few simple troubleshooting steps to help
diagnose the problem.
If the FUSION speaker has been installed by a professional
installation company, you should contact the company so the
technicians can assess the problem and advise you about
possible solutions.
There is no sound coming from the speakers
Verify that all connections from the source device and/or the
amplifier are connected correctly to the speaker terminals.
The audio is distorted
Verify that the source volume is not too loud for the speaker,
and reduce the volume if necessary.
Verify that the panels surrounding the speaker on the vessel
are not rattling.
Verify that the source device and/or the amplifier are
connected to the speaker terminals correctly.
If the speaker is connected to an amplifier, verify that the
input level of the amplifier is matched to the output level of
the stereo. For more information, see the manual for the
amplifier.
Specifications
Max. power (Watts) 330 W
RMS power (Watts) 60 W
Efficiency (1 W/1 m) 91 dB
Frequency response 3 kHz to 20 kHz
Impedance 4 Ohm nominal
Impedance when connected to a
FUSION Signature Series speaker
2 Ohm nominal
Recommended amplifier power
(RMS)
From 25 to 140 W per channel
Diaphragm material Aluminum (hard dome)
Min. mounting depth (clearance) 31 mm (1
1
/
4
in.)
Mounting diameter (clearance) 51 mm (2 in.)
Compass-safe distance 110 cm (3 ft. 7
1
/
4
in.)
Operating temperature range From 0 to 50°C (from 32 to
122°F)
Storage temperature range From -20 to 70°C (from -4 to
158°F)
Water and dust rating IEC 60529 IP65 (protected
against dust and water ingress)
4 Installation Instructions

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fusion SG-TW10 and is the answer not in the manual?

Fusion SG-TW10 Specifications

General IconGeneral
BrandFusion
ModelSG-TW10
CategorySpeakers
LanguageEnglish

Related product manuals