T14SG SOFTWARE UPDATE MANUAL
[Updating procedure]
1. SD card format
1. You will rst want to format your SD card to the 14SG. If you are using an existing
SD card, any data previously saved to it will be deleted during the "format". We
suggest you either save this data on your computer or purchase a new card.
2. After inserting the new SD card into the transmitter, turn
on the power switch. You will see the word "FORMAT" if
you have not previously used this card in the transmitter.
3. Please select "YES" and touch “RTN” .
4. The following screen is displayed during
formatting.
5. When the format is completed, the following screen is
displayed.
6. Turn o the power switch and remove the SD card from
its slot.
2. Preparing the software update card.
1. Please unzip the zipped le. The following les will be created.
・T14sgUpdate.exe ... File copy utility
・T14sgUpdate.dat ... Information le for T14sgUpdate.exe
・T14SG_UPDATE.dat … Identied le of T14SG
・T14SG_TS.bin ... Update le of T14SG (piece 3)
・T14SG_AP.bin ... Update le of T14SG (piece 2)
・T14SG_UPLD.bin ... Update le of T14SG (piece 1)
① Push to open.
②Slide in the direction of the
arrow on the battery cover.
③ Battery cover will open downward. ④ Insert the SD card in the
slot as shown above.
SD card slot
-1-
To Next Page
Need help?
General
