T14SG / FX-22 SOFTWARE UPDATE MANUAL
[Updating procedure]
1. SD card format
1. You will rst want to format your SD card to the 14SG/
FX-22. If you are using an existing SD card, any data
previously saved to it will be deleted during the
"format". We suggest you either save this data on your
computer or purchase a new card.
2. After inserting the new SD card
into the transmitter, turn on the
power switch. You will see the
word "FORMAT" if you have not
previously used this card in the
transmitter.
3. Please select "YES" and touch
“RTN”.
4. The following screen is displayed
during formatting.
5. When the format is completed,
the following screen is displayed.
6. Turn off the power switch and
remove the SD card from its slot.
① Push to open.
②Slide in the direction of the
arrow on the battery cover.
③ Battery cover will open downward. ④ SD card is inserted in a slot
by direction of a figure.
SD card slot
*It is releasable if a card is pushed once again.
① A side cover is opened.
② It inserts until it locks SD card into SD card slot.
*It is releasable if a card is pushed once again.
*Don't mistake the
both sides/ the
direction of
SD card.
SD card slot
T14SG:
FX-22:
2. Insert the 'formatted" SD card into a card reader in your
PC.
3. Please run "T14sgUpdate.exe".
4. Select the drive that your card reader is assigned to in
your PC.
5. After the Update files are copied to the SD card, the
following screens are displayed.
Click the "End" button.
Update
2. Preparing the software update card.
1. Please unzip the zipped le. The
following les will be created.
・T14sgUpdate.exe
・T14sgUpdate.dat
・T14SG_UPDATE.dat
・T14SG_TS.bin
・T14SG_AP.bin
・T14SG_UPLD.bin
- 1 -
To Next Page
Need help?
General
